M/T Models

CHECK PNP SWITCH POWER SUPPLY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect PNP switch harness connector.
3. Turn ignition switch ON.
4. Check voltage between PNP switch terminal 2 and ground with CONSULT-III or tester.
  Voltage: Battery voltage
  
  OK or NG
  
  OK : GO TO 3.
  
  NG : GO TO 2.
  
  Fig 1: Checking Voltage Between PNP Switch Terminal 2 And Ground
  Courtesy of NISSAN MOTOR CO., U.S.A.
DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E8, F8
- Harness for open or short between PNP switch and fuse
  Repair open circuit or short to ground or short to power in harness or connectors.
CHECK PNP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check harness continuity between PNP switch terminal 3 and ECM terminal 69.
  Refer to Wiring Diagram.
  
  Continuity should exist .
4. Also check harness for short to ground and short to power.
  OK or NG
  
  OK : GO TO 4.
  
  NG : Repair open circuit or short to ground or short to power in harness or connectors.
CHECK PNP SWITCH
Refer to POSITION SWITCH .

OK or NG

OK : GO TO 5.

NG : Replace PNP switch.
CHECK INTERMITTENT INCIDENT
Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

INSPECTION END