Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Continuously Variable Transmission (CVT) >> Service Information >> DTC P0720 Vehicle Speed Sensor CVT (Secondary Speed Sensor) >> DTC Confirmation Procedure

DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.
NOTE: If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.

After the repair, touch "ERASE" on "SELF-DIAG RESULTS" and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III 

  1. Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
  2. Start engine and maintain the following conditions for at least 12 consecutive seconds.

    ACC PEDAL OPEN: More than 1.0/8 

    RANGE: "D" position 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

  3. If DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST 

Follow the procedure "WITH CONSULT-III".

scientia non olet · About Mike's Workshop Manuals