Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System - DTCS P0506 To P2A00 (MR20DE Except CALIFORNIA)) >> DTC P1715 Input Speed Sensor (Primary Speed Sensor) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Always drive vehicle at a safe speed.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-III

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Start engine.
  4. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

    WITH GST

    Follow the procedure "WITH CONSULT-III" above.

scientia non olet · About Mike's Workshop Manuals