Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Control System - DTCS P0171 To P0500 (MR20DE Except CALIFORNIA)) >> DTC P0340 CMP Sensor (Phase) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10.5V with ignition switch ON  .

  1. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  2. Check 1st trip DTC.
  3. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

    If 1st trip DTC is not detected, go to next step.

  4. Maintain engine speed at more than 800 RPM for at least 5 seconds.
  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals