Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - DTCS P0643 To P2A00 (MR20DE-CALIFORNIA)) >> DTC P1564 ASCD Steering Switch >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
  1. Turn ignition switch ON.
  2. Wait at least 10 seconds.
  3. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
  4. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
  5. Press RESUME/ACCELERATE switch for at least 10 seconds, then release it and wait at least 10 seconds.
  6. Press SET/COAST switch for at least 10 seconds, then release it and wait at least 10 seconds.
  7. Check DTC.
  8. If DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals