Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2009 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - DTCS P0643 To P2A00 (MR20DE-CALIFORNIA)) >> DTC P1217 Engine Over Temperature >> Overall Function Check >> With Consult-III

With Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Check the coolant level in the reservoir tank and radiator.

    Allow engine to cool before checking coolant level  .

    If the coolant level in the reservoir tank and/or radiator is below the proper range, skip the following steps and go to "DIAGNOSIS PROCEDURE ".

  2. Confirm whether customer filled the coolant or not. If customer filled the coolant, skip the following steps and go to "DIAGNOSIS PROCEDURE "
  3. Turn ignition switch ON.
    Fig 1: Checking Coolant Level In Reservoir Tank
    G04875329Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Perform "COOLING FAN" in "ACTIVE TEST" mode with CONSULT-III.
  5. If the results are NG, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals