DTC Confirmation Procedure: Notes

WARNING: This page is about a different variant/trim than selected.

NOTE:

If DTC P0456 is displayed with P0442, first perform trouble diagnosis for DTC P0456.
After repair, make sure that the hoses and clips are installed properly.

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION:

Open engine hood before conducting following procedure .
If any of following conditions are met just before the DTC confirmation procedure, leave the vehicle for more than 1 hour .
- Fuel filler cap is removed .
- Refilled or drained the fuel .
- EVAP component parts is/are removed .
Before performing the following procedure, confirm that battery voltage is more than 11V at idle .