DTC Confirmation Procedure

CAUTION: Always drive vehicle at a safe speed.

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-III

Turn ignition switch ON.

Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT-III. Then check the "P/N POSI SW" signal under the following conditions.

DATA MONITOR REFERENCE CHART

Position (Selector lever)	Known-good signal
N or P position (CVT) Neutral position (M/T)	ON
Except above	OFF

If NG, go to "DIAGNOSIS PROCEDURE ".

If OK, go to following step.

Select "DATA MONITOR" mode with CONSULT-III.
Start engine and warm it up to normal operating temperature.

Maintain the following conditions for at least 60 consecutive seconds.

ENG SPEED CONDITIONS REFERENCE CHART

ENG SPEED	More than 1, 300 RPM
COOLAN TEMP/S	More than 70°C (158°F)
B/FUEL SCHDL	2.1 - 31.8 msec
VHCL SPEED SE	More than 64 km/h (29 MPH)
Selector lever	Suitable position

Check 1st trip DTC.
If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".