DTC Confirmation Procedure

• If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is between 10V and 16V at idle  .

WITH CONSULT-III

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
2. Start engine and warm it up to the normal operating temperature.
3. Maintain the following conditions for at least 10 consecutive seconds.

   Hold the accelerator pedal as steady as possible.

   TESTING CONDITION REFERENCE CHART
   
   

   ENG SPEED	1, 200 - 2, 000 RPM (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 60°C (140°F)
   B/FUEL SCHDL	More than 4.25 msec
   Shift lever	P or N position (CVT) Neutral position (M/T)

4. Let engine idle for 10 seconds.
5. Check 1st trip DTC.
6. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

   If 1st trip DTC is not detected, go to next step.

7. Maintain the following conditions for at least 10 consecutive seconds.
   TESTING CONDITION REFERENCE CHART
   
   

   ENG SPEED	1, 200 - 3, 175 RPM (A constant rotation is maintained.)
   COOLAN TEMP/S	More than 65°C (149°F)
   Shift lever	1st or 2nd position
   Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

8. Check 1st trip DTC.
9. If 1st trip DTC is detected, go to "DIAGNOSIS PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT-III" above.