Active Test Mode

CAUTION:

Never perform active test while driving vehicle.
Make sure to completely bleed air from brake system.
The active test cannot be performed with the ABS warning lamp and brake warning lamp are on.
ABS warning lamp and brake warning lamp are on during active test.

NOTE:

When active test is performed while depressing the pedal, the pedal depression amount will change. This is normal. (Only solenoid valve and ABS motor.)
"TEST IS STOPPED" is displayed 10 seconds after operation start.
After "TEST IS STOPPED" is displayed, to perform test again.

Test Item

ABS SOLENOID VALVE

For ABS solenoid valve, touch "Up", "Keep", and "Down". Then use screen monitor to check that solenoid valve operates as shown in solenoid valve operation chart.

TEST ITEM REFERENCE

Test item

Display item

Display

Keep

Down

FR RH SOL

FR RH IN SOL

Off

FR RH OUT SOL

Off

On⁽¹⁾

FR LH SOL

FR LH IN SOL

Off

FR LH OUT SOL

Off

On⁽¹⁾

RR RH SOL

RR RH IN SOL

Off

RR RH OUT SOL

Off

On⁽¹⁾

RR LH SOL

RR LH IN SOL

Off

RR LH OUT SOL

Off

On⁽¹⁾

⁽¹⁾	On for 1 to 2 seconds after the touch, and then Off.

ABS MOTOR

Touch "On" and "Off" on screen. Make sure motor relay and actuator relay operates as shown in table below.

TEST ITEM REFERENCE

Test item

Display item

Display

Off

ABS MOTOR

MOTOR RELAY

Off

ACTUATOR RLY ⁽¹⁾

⁽¹⁾	A brief moment of On/Off condition occurs every 20 seconds after ignition switch turned ON. This is not malfunction because it is an operation for checking.