With Consult-III

TESTING CONDITION: 

Steps 4 and 7 may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

1. Start engine (TCS switch or VDC switch OFF).
2. Select "DATA MONITOR" mode with CONSULT-III.
3. Press MAIN switch and make sure that CRUISE indictor lights up.
4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   SPEED REFERENCE CHART
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position

5. Check 1st trip DTC.
6. If 1st trip DTC is detected, go to , "DIAGNOSIS PROCEDURE ".

   If 1st trip DTC is not detected, go to the following step.

7. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   SPEED REFERENCE CHART
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position
   Driving location	Depress the brake pedal for more than 5 seconds so as not to come off from the above-mentioned vehicle speed.

8. Check 1st trip DTC.
9. If 1st trip DTC is detected, go to , "DIAGNOSIS PROCEDURE ".