DTC P1564 ASCD Steering Switch: Wiring Diagram

NOTE: For references to PG-Power, see POWER SUPPLY, GROUND & CIRCUIT ELEMENTS - QUEST .

Fig 1: ASCD Steering Switch - Wiring Diagram

Courtesy of NISSAN MOTOR CO., U.S.A.

Specification data are reference values and are measured between each terminal and ground.

CAUTION: Never use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECM's transistor. Use a ground other than ECM terminals, such as the ground.

TERMINALS VOLTAGE REFERENCE

TERMINAL NO.	WIRE COLOR	ITEM	CONDITION	DATA (DC Voltage)
67	B	Sensor ground	[Engine is running] Warm-up condition Idle speed	Approximately 0 V
99	G/Y	ASCD steering switch	[Ignition switch: ON] ASCD steering switch: OFF	Approximately 4 V
			[Ignition switch: ON] MAIN switch: Pressed	Approximately 0 V
			[Ignition switch: ON] CANCEL switch: Pressed	Approximately 1 V
			[Ignition switch: ON] RESUME/ACCELERATE switch: Pressed	Approximately 3 V
			[Ignition switch: ON] SET/COAST switch: Pressed	Approximately 2 V