Diagnosis Procedure

INSPECTION START
With CONSULT-III
1. Turn ignition switch ON.
2. Select "SELF-DIAG RESULTS" mode with CONSULT-III.
3. Touch "ERASE".
4. Perform DTC Confirmation Procedure.
  See , "DTC CONFIRMATION PROCEDURE ".
5. Is the DTC U1010 displayed again?
With GST
1. Turn ignition switch ON.
2. Select Service $04 with GST.
3. Perform DTC Confirmation Procedure.
  See , "DTC CONFIRMATION PROCEDURE ".
4. Is the DTC U1010 displayed again?
Yes or No

Yes: GO TO 2.

No: INSPECTION END
REPLACE ECM
1. Replace ECM.
2. Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to NVIS (NISSAN VEHICLE IMMOBILIZER SYSTEM-NATS) .
3. Perform , "VIN REGISTRATION ".
4. Perform , "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
5. Perform , "THROTTLE VALVE CLOSED POSITION LEARNING ".
6. Perform , "IDLE AIR VOLUME LEARNING ".
INSPECTION END