Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2009 >> 350Z Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Engine Control System - Introduction) >> Function Diagnosis >> On Board Diagnostic (OBD) System >> Generic Scan Tool (GST) Function >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2009 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Connect GST to data link connector, which is located under LH dash panel near the hood opener handle.
    Fig 1: Identifying Data Link Connector And Brake Pedal
    G04900111Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation manual.

    (*: Regarding GST screens in this part, sample screens are shown.)

    Fig 2: Sample Screen Display
    G04874897Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Perform each diagnostic service according to each service procedure.

    For further information, see the GST Operation Manual of the tool maker  .

    Fig 3: Screen Display - Readiness Test
    G04874898Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals