Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 192 (Engine Control System - DTCS U1000 To P0159) >> DTC P0125 ECT Sensor >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: Identifying CONSULT-II Display - DATA MONITOR
    G04900167Courtesy of NISSAN NORTH AMERICA, INC.
  3. Check that "COOLAN TEMP/S" is above 20°C (68°F).

    If it is above 20°C (68°F), the test result will be OK. 

    If it is below 20°C (68°F), go to following step. 

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than 20°C (68°F) within 65 minutes, stop engine because the test result will be OK. 

  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".