Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission) >> On-Vehicle Service >> Control Valve, TCM and A/T Fluid Temperature Sensor 2 >> Control Valve And TCM Removal And Installation >> Removal

Control Valve And TCM Removal And Installation: Removal

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative battery terminal.
  2. Drain A/T fluid. Refer to "A/T FLUID ".
  3. Disconnect A/T assembly harness connector.
  4. Remove snap ring from A/T assembly harness connector.
    Fig 1: Identifying A/T Assembly Harness Connector
    G04875907
  5. Push A/T assembly harness connector.
    CAUTION: Do not damage connector.
    Fig 2: Identifying A/T Assembly Harness Connector
    G04875908
  6. Remove oil pan and oil pan gasket. Refer to "REMOVAL ".
  7. Straighten the terminal clip to free the terminal cord assembly for A/T fluid temperature sensor 2 harness.
  8. Disconnect A/T fluid temperature sensor 2 connector.
    CAUTION: Do not damage connector.
    Fig 3: Connecting A/T Fluid Temperature Sensor 2 Connector
    G04901115
  9. Straighten terminal clip to free the revolution sensor harness.
    Fig 4: Identifying Terminal Clip
    G04875914
  10. Disconnect revolution sensor connector.
    CAUTION: Do not damage connector.
  11. Remove bolts (A), (B) and (C) from control valve with TCM.
    BOLT LENGTH CHART

    Bolt symbol Length mm (in) Number of bolts
    A 42 (1.65) 5
    B 55 (2.17) 6
    C 40 (1.57) 1
    Fig 5: Identifying Bolts Location
    G04901118
  12. Remove control valve with TCM from transmission case.
    CAUTION: When removing, be careful with the manual valve notch and manual plate height. Remove it vertically.
    Fig 6: Assembling Manual Valve Cutout
    G04875916
  13. Remove A/T fluid temperature sensor 2 with bracket from control valve with TCM.
    Fig 7: Identifying A/T Fluid Temperature Sensor 2
    G04875917
  14. Remove bracket from A/T fluid temperature sensor 2.
    Fig 8: Identifying A/T Fluid Temperature Sensor 2 Connector
    G04875918
  15. Remove O-ring from A/T assembly harness connector.
    Fig 9: Identifying O-Ring In A/T Assembly Harness Connector
    G04875919
  16. Disconnect TCM connectors.
    CAUTION: Do not damage connectors.
    Fig 10: Connecting TCM Connector
    G04875920
  17. Remove A/T assembly harness connector from control valve with TCM using suitable tool.
    Fig 11: Identifying A/T Assembly Harness Connector
    G04875921
  18. Disconnect TCM connector and park/neutral position switch connector
    CAUTION: Do not damage connectors.
    Fig 12: Identifying TCM Connector And Park/Neutral Position (PNP) Switch Connector
    G04875922
scientia non olet · About Mike's Workshop Manuals