Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission) >> DTC P1710 A/T Fluid Temperature Sensor Circuit >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
    Fig 1: Identifying CONSULT II Display - SELECT DIAG MODE
    G04899604
  3. Start engine and maintain the following conditions for at least 10 minutes (Total). (It is not necessary to maintain continuously.)

    VHCL SPEED SE: 10 km/h (6 MPH) or more 

    THRTL POS SEN: More than 1.0/8 

    Selector lever: "D" position 

  4. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals