Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS P0447 To P0850 (Qr25DE) >> DTC P0500 VSS >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

  1. Start engine.
  2. Read "VHCL SPEED SE" in "DATA MONITOR" mode with CONSULT-III. The vehicle speed on CONSULT-III should exceed 10 km/h (6 MPH) when rotating wheels with suitable gear position.

    If NG, go to "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-III.
  4. Warm engine up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    ENGINE SPEED REFERENCE

    ENG SPEED More than 1, 800 RPM (M/T)
    More than 1, 600 RPM (CVT)
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUEL SCHDL 4.5 - 31.8 msec (M/T)
    6.0 - 31.8 msec (CVT)
    Shift lever Suitable position
    PW/ST SIGNAL OFF
  6. Check 1st trip DTC.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals