Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (MEXICO) >> Component Diagnosis [For MEXICO] >> P0603 ECM Power Supply >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK ECM POWER SUPPLY
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the voltage between ECM harness connector and ground.
      TERMINALS VOLTAGE REFERENCE

      ECM Ground Voltage
      Connector Terminal
      F8 77 Ground Battery voltage

    Is the inspection result normal?

    YES: GO TO  3.

    NO: GO TO 2.

  2. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E8, F122
    • 20A fuse (No. 62)
    • IPDM E/R harness connector E15
    • Harness for open or short between ECM and battery

      Repair or replace harness or connectors.

  3. CHECK INTERMITTENT INCIDENT

    Refer to "INTERMITTENT INCIDENT ".

    Is the inspection result normal?

    YES: GO TO 4.

    NO: Repair or replace harness or connectors.

  4. PERFORM DTC CONFIRMATION PROCEDURE
    1. Erase DTC.
    2. Perform DTC CONFIRMATION PROCEDURE. 

    See "DTC LOGIC ".

    Is the 1st trip DTC P0603 displayed again?

    YES: GO TO 5.

    NO: INSPECTION END

  5. REPLACE ECM
    1. Replace ECM.
    2. Go to "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement ".

      INSPECTION END

scientia non olet · About Mike's Workshop Manuals