Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (MEXICO) >> Component Diagnosis [For MEXICO] >> P0327, P0328 KS >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

  1. PRECONDITIONING

    If DTC CONFIRMATION PROCEDURE has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    TESTING CONDITION: 

    Before performing the following procedure, confirm that battery voltage is more than 10V at idle. 

    GO TO 2.

  2. PERFORM DTC CONFIRMATION PROCEDURE
  1. Start engine and run it for at least 5 seconds at idle speed.
  2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES: GO TO "DIAGNOSIS PROCEDURE ".

    NO: INSPECTION END

scientia non olet · About Mike's Workshop Manuals