Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (MEXICO) >> Component Diagnosis [For MEXICO] >> P0327, P0328 KS >> Component Inspection

Component Inspection

  1. CHECK KNOCK SENSOR
    1. Turn ignition switch OFF.
    2. Disconnect knock sensor harness connector.
    3. Check resistance between knock sensor terminals as follows.
      NOTE: It is necessary to use an ohmmeter which can measure more than 10 MΩ.
      TERMINALS RESISTANCE REFERENCE

      Terminals Resistance
      1 and 2 Approx. 532 - 588 kΩ [at 20°C (68°F)]
    CAUTION: Do not use any knock sensors that have been dropped or physically damaged. Use only new ones.

    Is the inspection result normal?

    YES: INSPECTION END

    NO: Replace knock sensor.

scientia non olet · About Mike's Workshop Manuals