Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Rogue SL, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (MEXICO) >> Component Diagnosis [For MEXICO] >> P0132 A/F Sensor 1 >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK GROUND CONNECTION
    1. Turn ignition switch OFF.
    2. Check ground connection E21. Refer to Ground Inspection in "CIRCUIT INSPECTION ".

    Is the inspection result normal?

    YES: GO TO 2.

    NO: Repair or replace ground connection.

  2. CHECK AIR FUEL RATIO (A/F) SENSOR 1 POWER SUPPLY CIRCUIT
    1. Disconnect A/F sensor 1 harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between A/F sensor 1 harness connector and ground.
      TERMINALS VOLTAGE REFERENCE

      A/F sensor 1 Ground Voltage
      Connector Terminal
      F27 4 Ground Battery voltage

    Is the inspection result normal?

    YES: GO TO  4.

    NO: GO TO 3.

  3. DETECT MALFUNCTIONING PART

    Check the following.

    • Harness connectors E6, F123
    • IPDM E/R harness connector E14
    • 15A fuse (No. 63)
    • Harness for open or short between A/F sensor 1 and fuse

      Repair or replace harness or connectors.

  4. CHECK A/F SENSOR 1 INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between A/F sensor 1 harness connector and ECM harness connector.
      TERMINALS CONTINUITY REFERENCE

      A/F sensor 1 ECM Continuity
      Connector Terminal Connector Terminal
      F27 1 F8 45 Existed
      2 49
    4. Check the continuity between A/F sensor 1 harness connector or ECM harness connector and ground.
      TERMINALS CONTINUITY REFERENCE

      A/F sensor 1 ECM Ground Continuity
      Connector Terminal Connector Terminal
      F27 1 F8 45 Ground Not existed
      2 49
    5. Also check harness for short to power.

    Is the inspection result normal?

    YES: GO TO 5.

    NO: Repair open circuit or short to ground or short to power in harness or connectors.

  5. CHECK INTERMITTENT INCIDENT

    Perform "INTERMITTENT INCIDENT ".

    Is the inspection result normal?

    YES: GO TO 6.

    NO: Repair or replace.

  6. REPLACE AIR FUEL RATIO (A/F) SENSOR 1

    Replace air fuel ratio (A/F) sensor 1.

    CAUTION:
    • Discard any A/F sensor which has been dropped from a height of more than 0.5 m (19.7 in) onto a hard surface such as a concrete floor; use a new one.
    • Before installing new A/F sensor, clean exhaust system threads using Oxygen Sensor Thread Cleaner tool J-43897-18 or J-43897-12 and approved anti-seize lubricant.

    INSPECTION END

scientia non olet · About Mike's Workshop Manuals