Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS U1000 Through P0153 >> DTC P0133, P0153 A/F Sensor 1 >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1minute under no load.
  6. Let engine idle for 1 minute.
  7. Select "A/F SEN1(B1) P1278/P1279" (for DTC P0133) or "A/F SEN1(B1) P1288/P1289" (for DTC P0153) of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT-III.
  8. Touch "START".

    If "COMPLETED" appears on CONSULT-III screen, go to step  12.

    If "COMPLETED" does not appear on CONSULT-III screen, go to the following step.

  9. After perform the following procedure"TESTING" will be displayed on the CONSULT-III screen.
    1. Increase the engine speed up to 4, 000 to 5, 000 rpm and keep it for 10 seconds.
    2. Fully release accelerator pedal and then let engine idle for about 10 seconds.

      If "TESTING" is not displayed after 10 seconds, refer to  "TROUBLE DIAGNOSIS - SPECIFICATION VALUE ".

  10. Wait for about 20 seconds at idle at under the condition that "TESTING" is displayed on the CONSULT-III screen.
  11. Make sure that "TESTING" changes to "COMPLETED".

    If "TESTING" changed to "OUT OF CONDITION", refer to  "TROUBLE DIAGNOSIS - SPECIFICATION VALUE ".

  12. Make sure that "OK" is displayed after touching "SELF-DIAG RESULT".

    If "NG" is displayed, go to "DIAGNOSTIC PROCEDURE ".

scientia non olet · About Mike's Workshop Manuals