Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - DTCS U1000 Through P0153 >> DTC P0132, P0152 A/F Sensor 1 >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

  1. Start engine and warm it up to normal operating temperature.
  2. Select "A/F SEN1 (B1)" or "A/F SEN1 (B2)" in "DATA MONITOR" mode with CONSULT-III.
  3. Check "A/F SEN1 (B1)" or "A/F SEN1 (B2)" indication.

    If the indication is constantly approx. 5V, go to "DIAGNOSTIC PROCEDURE ".

    If the indication is not constantly approx. 5V, go to next step.

  4. Turn ignition switch OFF and wait at least 10 seconds.
  5. Turn ignition switch ON.
  6. Turn ignition switch OFF and wait at least 10 seconds.
  7. Restart engine.
  8. Drive and accelerate vehicle to more than 40 km/h (25 MPH) within 20 seconds after restarting engine.
  9. Maintain the following conditions for about 20 consecutive seconds.
    VEHICLE SPEED CONDITION

    ENG SPEED 1, 000 - 3, 200 rpm
    VHCL SPEED SE More than 40 km/h (25 MPH)
    B/FUEL SCHDL 1.5 - 9.0 msec
    Gear position Suitable position
    NOTE:
    • Keep the accelerator pedal as steady as possible during the cruising.
    • If this procedure is not completed within 1 minute after restarting engine at step 4, return to step 4.
  10. Check 1st trip DTC.
  11. If 1st trip DTC is displayed, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals