Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Frontier XE >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System (Qr25DE) >> Component Diagnosis >> P1564 ASCD Steering Switch >> DTC Confirmation Procedure

DTC Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

With CONSULT-III

  1. Turn ignition switch ON.
  2. Wait at least 10 seconds.
  3. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
  4. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
  5. Press RESUME/ACCELERATE switch for at least 10 seconds, then release it and wait at least 10 seconds.
  6. Press SET/COAST switch for at least 10 seconds, then release it and wait at least 10 seconds.
  7. Check DTC.
  8. If DTC is detected, go to "DIAGNOSIS PROCEDURE ".

With GST

Follow the procedure "WITH CONSULT-III" above.

scientia non olet · About Mike's Workshop Manuals