Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2008 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System (Hybrid)) >> Component Diagnosis >> P0011 IVT Control >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • If DTC P0011 is displayed with DTC P0075, first perform the trouble diagnosis for "DTC LOGIC ".
  • If DTC P0011 is displayed with DTC P0340, first perform the trouble diagnosis for "DTC LOGIC ".
DTC DETECTING CONDITION AND POSSIBLE CAUSE

DTC No. Trouble diagnosis name Detecting condition Possible cause
P0011 Intake valve timing control performance There is a gap between angle of target and phase-control angle degree.
  • Crankshaft position sensor (POS)
  • Camshaft position sensor (PHASE)
  • Intake valve control solenoid valve
  • Accumulation of debris to the signal pick-up portion of the camshaft
  • Timing chain installation
  • Foreign matter caught in the oil groove for intake valve timing control
scientia non olet · About Mike's Workshop Manuals