Intake Valve Timing Control Solenoid Valve
- Disconnect intake valve timing control solenoid valve harness connector.
- Check resistance between intake valve timing control solenoid valve as follows.TERMINAL RESISTANCE REFERENCE
Terminal Resistance 1 and 2 8Ω [at 20°C (68°F)] 1 or 2 and ground ∞ Ω
(Continuity should not exist.)Courtesy of NISSAN MOTOR CO., U.S.A.
If NG, replace intake valve timing control solenoid valve.
If OK, go to next step.
- Remove intake valve timing control solenoid valve.
- Provide 12V DC between intake valve timing control solenoid valve terminals and then interrupt it. Make sure that the plunger moves as shown in illustration.
CAUTION:
Do not apply 12V DC continuously for 5 seconds or more. Doing so may result in damage to the coil in intake valve timing control solenoid valve.
If NG, replace intake valve timing control solenoid valve.
NOTE:
Always replace O-ring when intake valve timing control solenoid valve is removed.