Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System - DTCS P0181 To P0500 (MR20DE)) >> DTC P0453 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different variant/trim than selected.
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with CONSULT-III.
  5. Make sure that "FUEL T/TMP SE" is more than 0°C (32°F).
  6. Wait at least 10 seconds.
  7. Check 1st trip DTC.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

scientia non olet · About Mike's Workshop Manuals