Power Window and Door Lock/Unlock Switch RH Power Supply Circuit Check

1. Turn ignition switch ON.
2. Check voltage between power window and door lock/unlock switch RH connector D104 terminal 8 and ground.

   8 - Ground :Battery voltage 

OK or NG 

OK: Replace power window and door lock/unlock switch RH. Refer to "FRONT DOOR ".

NG: GO TO 2.

Fig 1: Checking Voltage Between Power Window And Door Lock/Unlock Switch RH Connector D104 Terminal 8 And Ground

1. Turn ignition switch OFF.
2. Disconnect BCM and power window and door lock/unlock switch RH.
3. Check continuity between BCM connector (A) and power window and door lock/unlock switch RH connector (B).
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   A		B		Continuity
   Connector	Terminal	Connector	Terminal
   M20	68	D104	8	Yes

4. Check continuity between BCM connector (A) and ground.
   CONNECTOR TERMINAL CONTINUITY SPECIFICATION
   
   

   A		Ground	Continuity
   Connector	Terminal
   M20	68		No

   Fig 2: Checking Continuity Between BCM And Ground

   

OK or NG 

OK: Check the condition of the harness and the connector.

NG: Repair or replace harness.