Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0137 To P0443 >> DTC P0340, P0345 CMP Sensor (Phase) >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If 1st trip DTC is not detected, go to next step.

  5. Maintaining engine speed at more than 800 rpm for at least 5 seconds.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT-II Display - DATA MONITOR
    G04900036Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals