With Consult-II

TESTING CONDITION: 

Steps   4  and   5  may be conducted with the drive wheels lifted in the shop or by driving the vehicle. If a road test is expected to be easier, it is unnecessary to lift the vehicle. 

1. Start engine (VDC switch OFF).
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Press MAIN switch and make sure that CRUISE indicator lights up.
4. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   VHCL SPEED SE REFERENCE
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position

   Fig 1: CONSULT-II Display - DATA MONITOR

   Courtesy of NISSAN NORTH AMERICA, INC.

   If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".

   If 1st trip DTC is not detected, go to the following step.

5. Drive the vehicle for at least 5 consecutive seconds under the following condition.
   VHCL SPEED SE REFERENCE
   
   

   VHCL SPEED SE	More than 30 km/h (19 MPH)
   Shift lever	Suitable position
   Driving location	Depress the brake pedal for more than five seconds so as not to come off from the above-mentioned vehicle speed.

6. If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".