Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Frontier XE, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - Component Testing (VQ)) >> ASCD Brake Switch >> Component Inspection >> ASCD Clutch Switch

ASCD Clutch Switch

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Disconnect ASCD clutch switch harness connector.
  3. Check continuity between ASCD clutch switch terminals 1 and 2 under the following conditions.
    CONTINUITY REFERENCE CHART

    Condition Continuity
    Clutch pedal: Fully released Should exist.
    Clutch pedal: Slightly depressed Should not exist.

    If NG, adjust ASCD clutch switch installation, refer to "CLUTCH PEDAL ", and perform step  3 again.

    Fig 1: Checking Continuity Between ASCD Brake Switch Terminals 2 And 1
    G04875415Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals