Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Frontier XE, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - Component Testing (VQ)) >> ASCD Brake Switch >> Component Inspection >> ASCD Brake Switch

ASCD Brake Switch

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Disconnect ASCD brake switch harness connector.
  3. Check harness continuity between ASCD brake switch terminals 1 and 2 under the following conditions.
    CONTINUITY REFERENCE CHART

    Condition Continuity
    When brake pedal: Fully released. Should exist.
    When brake pedal: Slightly depressed. Should not exist.
    Fig 1: Checking Continuity Between ASCD Brake Switch Terminals 1 And 2
    G04895072Courtesy of NISSAN NORTH AMERICA, INC.

    If NG, adjust ASCD brake switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

scientia non olet · About Mike's Workshop Manuals