Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Altima SE, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Introduction (VQ35DE) >> On Board Diagnostic (OBD) System >> Diagnosis Tool Function >> Inspection Procedure

Inspection Procedure

  1. Turn ignition switch OFF.
  2. Connect "GST" to data link connector (2), which is located under LH dash panel near the hood opener handle (1).
    Fig 1: Identifying Data Link Connector And Hood Opener Handle
    G04886467Courtesy of NISSAN NORTH AMERICA, INC.
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation manual.

    (*: Regarding in this section, sample screens are shown.)

    Fig 2: GST Sample Screens Display
    G04874897Courtesy of NISSAN NORTH AMERICA, INC.
  5. Perform each diagnostic mode according to each service procedure.

    For further information, see the GST Operation Manual of the tool maker. 

    Fig 3: Generic Scan Tool Screen Display - READINESS TESTS
    G04874898Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals