Detailed Flow
- INTERVIEW FOR MALFUNCTION
Interview the symptom to the customer.
: GO TO 2
- SYMPTOM CHECK
Check the symptom from the customer's information.
: GO TO 3
- BASIC INSPECTION
Check the operation of each part. Check that any symptom occurs other than the interviewed symptom.
: GO TO 4
- SELF-DIAGNOSIS WITH CONSULT-III
Perform the self-diagnosis with CONSULT-III. Check that any DTC is detected.
Is any DTC detected?
YES: GO TO 5
NO: GO TO 6
- TROUBLE DIAGNOSIS BY DTC
Perform the trouble diagnosis for the detected DTC. Specify the malfunctioning part.
: GO TO 9
- FAIL-SAFE ACTIVATION CHECK
Check that the symptom is applied to the fail-safe activation.
Does the fail-safe activate?
YES: GO TO 7
NO: GO TO 8
- SYSTEM DIAGNOSIS
Perform the system diagnosis for the system that the fail-safe activates. Specify the malfunctioning part.
: GO TO 9
- SYMPTOM DIAGNOSIS
Perform the symptom diagnosis. Specify the malfunctioning part.
: GO TO 9
- MALFUNCTION PART REPAIR
Repair or replace the malfunctioning part.
: GO TO 10
- REPAIR CHECK (SELF-DIAGNOSIS WITH CONSULT-III)
Perform the self-diagnosis with CONSULT-III. Check that any DTC is not detected. Erase DTC if DTC is detected before the repair. Check that DTC is not detected again.
Is any DTC detected?
YES: GO TO 5
NO: GO TO 11
- REPAIR CHECK (OPERATION CHECK)
Check the operation of each part.
Does it operate normally?
YES: Inspection End.
NO: GO TO 3