Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Security Control System (Hybrid)) >> Intelligent Key System >> Component Diagnosis >> B2602 Shift Position >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • If DTC B2602 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to "DTC LOGIC ".
  • If DTC B2602 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to "DTC LOGIC ".
DTC DETECTION CONDITION POSSIBLE CAUSE

DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B2602 SHIFT POSITION BCM detects the following status for 10 seconds.
  • Shift position is in P position
  • Vehicle speed is 4km/h or more
  • Ignition switch is in the ON position
  • Harness or connectors (ECVT drive circuit is open or shorted)
  • ECVT device (detention swithc)
  • ABS actuator and electric unit (control unit)
scientia non olet · About Mike's Workshop Manuals