Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Altima Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Security Control System (Hybrid)) >> Intelligent Key System >> Component Diagnosis >> B2556 Push-Button Ignition Switch >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. CHECK PUSH-BUTTON IGNITION SWITCH
    1. Turn ignition switch OFF.
    2. Disconnect push-button ignition switch harness connector.
    3. Check continuity between push-button ignition switch terminals under the following conditions.
      Fig 1: Checking Continuity Between Push-Button Ignition Switch Terminals
      G05046589
      CONTINUITY REFERENCE CHART

      Push-button ignition switch   Condition Continuity
      Terminal
      1 4 Pressed Yes
      Not pressed No

    Is the inspection result normal? 

    YES: INSPECTION END.

    NO: Replace push-button ignition switch. Refer to "REMOVAL AND INSTALLATION ".

scientia non olet · About Mike's Workshop Manuals