Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2007 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Introduction (Qr25DE) (Except For CALIFORNIA) >> On Board Diagnostic (OBD) System >> Diagnosis Tool Function >> Inspection Procedure

Inspection Procedure

  1. Turn ignition switch OFF.
  2. Connect "GST" to data link connector (2), which is located under LH dash panel near the hood opener handle (1).
    Fig 1: Identifying Data Link Connector And Hood Opener Handle
    G04887849
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation manual.

    (*: Regarding GST screens in this section, sample screens are shown.)

    Fig 2: GST Sample Screen Display
    G04874897
  5. Perform each diagnostic mode according to each service procedure.

    For further information, see the GST Operation Manual of the tool maker. 

    Fig 3: Generic Scan Tool Display - Readiness Tests
    G04874898
scientia non olet · About Mike's Workshop Manuals