DTC Confirmation Procedure: Notes
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Never remove fuel filler cap during the DTC Confirmation Procedure.
NOTE:
- Make sure that EVAP hose are connected to EVAP canister purge volume control solenoid valve properly.
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
- Perform "DTC WORK SUPPORT" when the fuel level is between 1/4 to 3/4 full, and vehicle is placed on flat level surface .
- Open engine hood before conducting the following procedure .