Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U1000 To P0133 (Qr25DE) >> DTC P0130 A/F Sensor 1 >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Start engine and warm it up to normal operating temperature.
  2. Select "A/F SEN1 (B1)" in "DATA MONITOR" mode with CONSULT-II.
  3. Check "A/F SEN1 (B1)" indication.

    If the indication is constantly approx. 1.5V and does not fluctuates, go to "DIAGNOSTIC PROCEDURE ".

    If the indication fluctuates around 1.5V, go to next step.

  4. Select "A/F SEN 1 (B1) P1276" of "A/F SEN1" in "DTC WORK SUPPORT" mode with CONSULT-II.
    5. Fig 1: CONSULT-II Screen Display - A/F SEN1 (B1)
    G04191769Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Touch "START".
  6. When the following conditions are met, "TESTING" will be displayed on the CONSULT-II screen.
    Fig 2: CONSULT-II Screen Display - TESTING
    G04191770Courtesy of NISSAN MOTOR CO., U.S.A.
    CONDITIONS REFERENCE

    ENG SPEED 1, 750 - 3, 200 rpm
    Vehicle speed More than 64 km/h (40 MPH)
    B/FUEL SCHDL 1.0 - 8.0 msec
    COOLANT TEMP/S More than 70°C (158°F)
    Shift lever D position with OD ON (A/T models)
    5th position (M/T models)

    If "TESTING" is not displayed after 20 seconds, retry from step 2. 

  7. Release accelerator pedal fully.
    NOTE: Never apply brake during releasing the accelerator pedal.
  8. Make sure that "TESTING" changes to "COMPLETED".

    If "TESTING" changed to "OUT OF CONDITION", retry from step 6. 

    9. Fig 3: CONSULT-II Screen Display - COMPLETED
    G04191771Courtesy of NISSAN MOTOR CO., U.S.A.
  9. Make sure that "OK" is displayed after touching "SELF-DIAG RESULT".

    If "NG" is displayed, go to "DIAGNOSTIC PROCEDURE ".

scientia non olet · About Mike's Workshop Manuals