Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Sentra Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0850 To P2A00 (QG18DE) >> DTC P2A00 A/F Sensor 1 >> Overall Function Check >> With GST

With GST

  1. Start engine and warm it up to normal operating temperature.
  2. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in D position with "OD" OFF (A/T) or 3rd position (M/T).
    NOTE: Keep accelerator pedal as steady as possible during the cruising.
  3. Set D position with "OD" OFF (A/T) or 4th position (M/T), then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).
    NOTE: Never apply brake during releasing the accelerator pedal.
  4. Repeat steps 2 to 3 five times.
  5. Stop the vehicle and turn ignition switch OFF.
  6. Wait at least 10 seconds and restart engine.
  7. Repeat steps 2 to 3 five times.
  8. Stop the vehicle and connect GST to the vehicle.
  9. Make sure that no DTC is displayed.

    If the 1st trip DTC is displayed, go to "DIAGNOSTIC PROCEDURE ".

scientia non olet · About Mike's Workshop Manuals