Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P0137 To P0445 >> DTC P0340, P0345 CMP Sensor (Phase) >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Crank engine for at least 2 seconds and run it for at least 5 seconds at idle speed.
  4. If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".

    If 1st trip DTC is not detected, go to next step.

  5. Maintaining engine speed at more than 800 rpm for at least 5 seconds.
  6. If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".
    Fig 1: Consult-II DATA MONITOR Display Screen
    G04080353Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals