With CONSULT-II

1. Replace thermostat with new one. Refer to "WATER INLET AND THERMOSTAT ASSEMBLY ".

   Use only a genuine NISSAN thermostat as a replacement. If an incorrect thermostat is used, the MIL may come on.

2. Turn ignition switch ON.
3. Select "COOLAN TEMP/S" in "DATA MONITOR" mode with CONSULT-II.
4. Check that the "COOLAN TEMP/S" is above 60°C (140°F).

   If it is below 60°C (140°F), go to following step.

   If it is above 60°C (140°F), cool down the engine to less than 60°C (140°F), then retry from step  1.

5. Drive vehicle for 10 consecutive minutes under the following conditions.

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

Fig 1: CONSULT-II Screen Display - DATA MONITOR

Courtesy of NISSAN MOTOR CO., U.S.A.