Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Murano SL, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1217 To P2A03 >> DTC P1572 ASCD Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

  1. Turn ignition switch OFF.
  2. Disconnect stop lamp switch harness connector.
  3. Check continuity between stop lamp switch terminals 3 and 4 under the following conditions.
CONDITION CONTINUITY CHART

Condition Continuity
Brake pedal: Fully released Should not exist
Brake pedal: Slightly depressed Should exist

If NG, adjust stop lamp switch installation, refer to "BRAKE PEDAL ", and perform step  3 again.

Fig 1: Checking Harness Continuity Between Stop Lamp Switch Terminals 1 And 2
G04216404Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals