Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Maxima SL >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS U1000 To P0157 >> DTC P0011, P0021 IVT Control >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

  1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
    2. Fig 1: CONSULT-II Data Monitor Display
    G04160209Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Start engine and warm it up to the normal operating temperature.
  3. Maintain the following conditions for at least 6 consecutive seconds.

    Hold the accelerator pedal as steady as possible.

    CONDITION REFERENCE

    ENG SPEED 1, 200 - 2, 000 rpm (A constant rotation is maintained.)
    COOLAN TEMP/S 60 - 120°C (140 - 248°F)
    Shift lever P or N position
  4. Let engine idle for 10 seconds.
  5. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If the 1st trip DTC is not detected, go to next step.

  6. Maintain the following conditions for at least 20 consecutive seconds.
    CONDITION REFERENCE

    ENG SPEED 1, 700 - 3, 175 rpm (A constant rotation is maintained.)
    COOLAN TEMP/S 70 - 105°C (158 - 221°F)
    Shift lever 1st or 2nd position
    Driving location uphill Driving vehicle uphill
    (Increased engine load will help maintain the driving conditions required for this test.)
  7. If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals