Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Altima SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Control System - Introduction (Qr25DE)) >> Basic Service Procedure >> Fuel Pressure Check >> Fuel Pressure Release >> Without CONSULT-II

Without CONSULT-II

WARNING: This page is about a different variant/trim than selected.
  1. Remove fuel pump fuse located in IPDM E/R.
  2. Start engine.
  3. After engine stalls, crank it two or three times to release all fuel pressure.
  4. Turn ignition switch OFF.
  5. Reinstall fuel pump fuse after servicing fuel system.
    Fig 1: Locating IPDM E/R And Fuel Pump Fuse
    G04160123Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals