Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2006 >> Altima SE-R, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Entertainment Systems >> Audio, Visual, Navigation & Telephone System >> Navigation System >> Ignition Signal Check for Display Control Unit

Ignition Signal Check for Display Control Unit

  1. CHECK IGNITION SIGNAL 
    1. Disconnect display control unit connector.
    2. Turn ignition switch ON.
    3. Check voltage between display control unit harness connector M94 terminal 12 and ground.

      Battery voltage should exist. 

    Fig 1: Checking Voltage Between Display Control Unit Connector M94 Terminal 12 And Ground
    G04171716Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    OK: Replace display control unit. Refer to DISPLAY CONTROL UNIT  .

    NG: Check harness for open or short between display control unit and fuse.

scientia non olet · About Mike's Workshop Manuals