Data Monitor Mode (A/T)

WARNING: This page is about a different variant/trim than selected.

DATA MONITOR MODE (A/T)

Item	Display	Monitor item			Description	Remarks
Item	Display	TCM Input signals	Main signals	Selection from menu	Description	Remarks
Vehicle speed sensor 1 (A/T) (Revolution sensor)	VHCL/S SE.A/T [km/h] or [mph]	X	-	DOWN TRIANGLE	Vehicle speed computed from signal of revolution sensor is displayed.	When racing engine in N or P with vehicle stationary, CONSULT-II data may not indicate 0 km/h (0 mph).
Vehicle speed sensor 2 (Meter)	VHCL/S SE.MTR [km/h] or [mph]	X	-	DOWN TRIANGLE	Vehicle speed computed from signal of vehicle speed sensor is displayed.	Vehicle speed display may not be accurate under approx. 10 km/h (6 mph). It may not indicate 0 km/h (0 mph) when vehicle is stationary.
Throttle position sensor [accelerator pedal position (APP) sensor]	THRTL POS SEN [V]	X	-	DOWN TRIANGLE	Throttle position sensor signal voltage is displayed
A/T fluid temperature sensor	FLUID TEMP SE [V]	X	-	DOWN TRIANGLE	A/T fluid temperature sensor signal voltage is displayed. Signal voltage lowers as fluid temperature rises.
Battery voltage	BATTERY VOLT [V]	X	-		Source voltage of TCM is displayed.
Engine speed	ENGINE SPEED [rpm]	X	X	DOWN TRIANGLE	Engine speed, computed from engine speed signal, is displayed.	Engine speed display may not be accurate under approx. 800 rpm. It may not indicate 0 rpm even when engine is not running.
Turbine revolution sensor	TURBINE REV	X	-	DOWN TRIANGLE	Checks changing speed then performs oil pressure control and torque down control
Overdrive control switch	OVERDRIVE SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF state computed from signal of 3 position switch is displayed.
PN position (PNP) switch	PN POSI SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF state computed from signal of PN position SW is displayed.
R position switch	R POSITION SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF state computed from signal of R position SW is displayed.
D position switch	D POSITION SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF state computed from signal of D position SW is displayed.
2 position switch	2 POSITION SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF status, computed from signal of 2 position SW, is displayed.
1 position switch	1 POSITION SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF status, computed from signal of 1 position SW, is displayed.
ASCD cruise signal	ASCD.CRUIS E [ON/OFF]	X	-	DOWN TRIANGLE	Status of ASCD cruise signal is displayed. ON... Cruising state OFF... Normal running state
ASCD OD cut signal	ASCD.OD CUT [ON/OFF]	X	-	DOWN TRIANGLE	Status of ASCD OD release signal is displayed. ON... OD released OFF... OD not released
Kickdown switch	KICKDOWN SW [ON/OFF]	X	-	DOWN TRIANGLE	ON/OFF status, computed from signal of kickdown SW, is displayed.	This is displayed even when no kickdown switch is equipped.
Stop lamp switch	BRAKE SW [ON/OFF]	X	-	-	ON/OFF status is displayed. ON... Brake pedal is depressed. OFF... Brake pedal is released.
Selector lever position	SLCT LVR POSI	-	X	DOWN TRIANGLE	Selector lever position data, used for computation by TCM, is displayed.	A specific value used for control is displayed if fail-safe is activated due to error.
Vehicle speed	VEHICLE SPEED [km/h] or [mph]	-	X	DOWN TRIANGLE	Vehicle speed data, used for computation by TCM, is displayed.
Throttle position [Accelerator pedal position (APP) sensor]	THROTTLE POSI [/8]	-	X	-	Throttle position data, used for computation by TCM, is displayed.	A specific value used for control is displayed if fail-safe is activated due to error.
Gear position	GEAR	-	X	DOWN TRIANGLE	Gear position data used for computation by TCM, is displayed.
Line pressure duty	LINE PRES DTY [%]	-	X	-	Control value of line pressure solenoid valve, computed by TCM from each input signal, is displayed.
Torque converter clutch solenoid valve duty	TCC S/V DUTY [%]	-	X	-	Control value of torque converter clutch solenoid valve, computed by TCM from each input signal, is displayed.
Shift solenoid valve A	SHIFT S/V A [ON/OFF]	-	X	-	Control value of shift solenoid valve A, computed by TCM from each input signal, is displayed.	Control value of solenoid is displayed even if solenoid circuit is disconnected. The OFF signal is displayed if solenoid circuit is shorted.
Shift solenoid valve B	SHIFT S/V B [ON/OFF]	-	X	-	Control value of shift solenoid valve B, computed by TCM from each input signal, is displayed.
Overrun clutch solenoid valve	OVERRUN/C S/V [ON/OFF]	-	X	DOWN TRIANGLE	Control value of overrun clutch solenoid valve computed by TCM from each input signal is displayed.
Self-diagnosis display lamp [A/T check (position) indicator lamp]	SELF-D DP LMP [ON/OFF]	-	X	DOWN TRIANGLE	Control status of A/T check (position) indicator lamp is displayed.
Torque converter slip ratio	TC SLIP RATIO [0.000]	-	-	DOWN TRIANGLE	Ratio of engine revolution to input shaft revolution of torque converter.
Torque converter slip speed	TC SLIP SPEED [rpm]	-	-	DOWN TRIANGLE	Difference in revolution between input shaft revolution and torque converter input shaft revolution.	Display does not indicate engine is stopped even if 0 rpm - this is not a malfunction.
Voltage [V]		-	-	DOWN TRIANGLE	Value measured by voltage probe is displayed.
Frequency [Hz]		-	-	DOWN TRIANGLE	Value measured by pulse probe is displayed. If measurement is impossible, "#" sign is displayed. "#" sign is also displayed at the final data value until the measurement result is obtained.
DUTY-HI		-	-	DOWN TRIANGLE	Duty cycle value for measurement probe is displayed.
DUTY-LOW		-	-	DOWN TRIANGLE	Duty cycle value for measurement probe is displayed.
PLS WIDTH-HI		-	-	DOWN TRIANGLE	Measured pulse width of measurement probe is displayed.
PLS WIDTH-LOW		-	-	DOWN TRIANGLE	Measured pulse width of measurement probe is displayed.
X: Applicable -: Not applicable DOWN TRIANGLE : Option