Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System (QG18DE)) >> DTC P0181: FTT Sensor >> Diagnostic Trouble Codes Confirmation Procedure

Diagnostic Trouble Codes Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: CONSULT-II Display - DATA MONITOR Mode
    G02449891Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Wait at least 10 seconds.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

    If the result is OK, go to following step.

  4. Check "COOLAN TEMP/S" signal.

    If the signal is less than 50°C (122°F), the result will be OK.

    If the signal is above 50°C (122°F), go to the following step.

  5. Cool engine down until "COOLAN TEMP/S" signal is less than 50°C (122°F).
  6. Wait at least 10 seconds.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

WITH GST 

Follow the procedure "WITH CONSULT-II" above.

scientia non olet · About Mike's Workshop Manuals