Diagnostic Trouble Codes Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Always drive at a safe speed.
NOTE:
- If DTC P0011 is displayed with DTC P1111, first perform trouble diagnosis for DTC P1111. Refer to "DTC P1111 IVT CONTROL SOLENOID VALVE ".
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 10V and 16V at idle.
WITH CONSULT-II
- Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
- Start engine and warm it up to the normal operating temperature.
- Maintain the following conditions for at least 6 consecutive seconds.
Hold the accelerator pedal as steady as possible.
VEHICLE SPEED REFERENCEVHCL SPEED SE 100 - 120 km/h (63 - 75 MPH) ENG SPEED 600 - 2, 000 rpm COOLANT TEMP/S 60 - 120 °C (140 - 248 °F) B/FUEL SCHDL More than 6.0 msec Selector lever AT models: D position MT models: 5th position - Stop vehicle with engine running and let engine idle for 10 seconds.
- If 1 st trip DTC is detected, go to
"DIAGNOSTIC PROCEDURE ".
If 1 st trip DTC is not detected, go to next step.
- Maintain the following conditions for at least 10 consecutive seconds.ENGINE SPEED REFERENCE
ENG SPEED 1, 800 - 3, 175 rpm (A constant rotation is maintained.) COOLANT TEMP/S More than 70 °C Selector lever 1st or 2nd position Driving location uphill Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.) - If 1 st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
WITH GST
Follow the procedure "WITH CONSULT-II" above.